Yazar "Ozcan, F." seçeneğine göre listele

Listeleniyor 1 - 2 / 2
  • Küçük Resim Yok
    Öğe
    The influence of aggregate type on the strength and abrasion resistance of high strength concrete
    (ELSEVIER SCI LTD, 2008) Kilic, A.; Atis, C. D.; Teymen, A.; Karahan, O.; Ozcan, F.; Bilim, C.; Ozdemir, M.
    This paper examines the influence of aggregate type on the strength characteristics and abrasion resistance of high strength silica fume concrete. Five different aggregate types (gabbro, basalt, quartsite, limestone and sandstone) were used to produce high strength concrete containing silica fume. Silica fume replacement ratio with cement was 15% on a mass basis. Water-binder ratio was 0.35. The amount of hyperplasticizer was 4% of the binder content by mass. Gabbro concrete showed the highest compressive and flexural tensile strength and abrasion resistance, while sandstone showed the lowest compressive and flexural tensile strength and abrasion resistance. High abrasion resistant aggregate produced a concrete with high abrasion resistance. Three-month compressive strengths of concretes made with basalt, limestone and sandstone were found to be equivalent to the uniaxial compressive strengths of their aggregate rocks. However, the concretes made with quartsite and gabbro aggregate showed lower compressive strength than the uniaxial compressive strength of their aggregate rocks. (c) 2007 Elsevier Ltd. All rights reserved.
  • Küçük Resim Yok
    Öğe
    The influence of elevated temperature on strength and microstructure of high strength concrete containing ground pumice and metakaolin
    (ELSEVIER SCI LTD, 2016) Saridemir, M.; Severcan, M. H.; Ciflikli, M.; Celikten, S.; Ozcan, F.; Atis, C. D.
    A laboratory study is performed to evaluate the influence of elevated temperature on the strength and microstructural properties of high strength concretes (HSCs) containing ground pumice (GP), and blend of ground pumice and metakaolin (MK) mixture. Twelve different mixtures of HSCs containing GP and MM were produced, water-to-binder ratio was kept constant as 0.20. Hardened concrete specimens were exposed to 250 degrees C, 500 degrees C and 750 degrees C elevated temperatures increased with a heating rate of 5 degrees C/min. Ultrasound pulse velocity (U-pv), compressive strength (f(c)), flexural strength (f(fs)) and splitting tensile strength (f(sts)) values of concrete samples were measured on unheated control concrete and after air-cooling period of heated concrete. The crack formation and alterations in the matrix, interface and aggregate of HSCs were examined by X-ray diffraction (XRD), scanning electron microscope (SEM) and polarized light microscope (PLM) analyses. XRD, SEM and PLM analyses have shown that, increasing target temperature result with decrease in mechanical properties i.e. U-pv, f(c), f(fs) and f(sts) values. Elevated temperature also results with crack formation, and increasing target temperature caused more cracks. Alterations in the matrix, interface and aggregate were, also observed by these analyses. The experimental results indicate that concrete made with MK + GP blend together as a replacement of cement in mass basis behaved better than control concrete made with cement only, and concrete containing only GP as a cement replacement. (C) 2016 Elsevier Ltd. All rights reserved.