Effect of water saturation on Cerchar abrasivity index (CAI) of clay-rich rocks at different scratch lengths
Küçük Resim Yok
Tarih
2024
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Elsevier Science Sa
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
Predicting the cutter consumption rate of mechanical excavators using the Cerchar abrasivity index (CAI) results is possible. However, changing operational parameters in the field may cause differences between the estimated cutter consumption rate based on CAI test results and the real cutter consumption rate observed in the field. One of the essential parameters in the field that affects the cutter consumption rate is the increase in the water content of the excavated rocks. In theory, an increase in the water content of rocks is expected to reduce their abrasivity. In addition, the prediction of cutter consumption rate is based solely on CAI test results conducted on dry surfaces. However, especially during the excavation of low-strength clay-rich rocks, the excavated rock material can adhere to the cutters and block them, leading to a higher cutter consumption rate than initially predicted. This study aims to analyze the rock-pin interaction in CAI tests conducted on wet surfaces of clay-rich rocks and investigate the effect of water saturation on CAI at different scratch lengths. CAI tests were conducted on dry and wet surfaces of 20 clay-rich rocks with low strength at 10, 30, 50, and 70 mm scratch lengths, respectively. The relationships between the CAI test results obtained on dry and saturated rock surfaces were statistically analyzed for each scratch length. A positive linear correlation was found between CAI values obtained on dry (CAIDry) and saturated surfaces (CAISat) at each scratch length. The percentage variations in CAI values at each scratch length were analyzed in detail. It was found that 90 % of samples have higher CAIDry than CAISat at 10 mm scratch length. However, it was observed that as the scratch length increased, the relationship between the CAI values obtained in dry and saturated conditions changed, and the proportion of samples with CAIDry higher than CAISat decreased to 65 %, 55 %, and 25 % at scratch lengths of 30 mm, 50 mm, and 70 mm, respectively. In CAI tests conducted on saturated surfaces, it was observed that the excavated rock material adhered to the test pins, and as the scratch length increased, the increase in CAISat values was considered to be due to this situation. This study revealed the importance of considering the adhesion potential of rocks to cutters at water-saturated conditions for the accurate prediction of cutter consumption in the excavation of clay-rich rocks.
Açıklama
Anahtar Kelimeler
Cerchar abrasivity index, Mechanical excavation, Clay-rich rocks, Water saturation
Kaynak
Wear
WoS Q Değeri
Q1
Scopus Q Değeri
Q1
Cilt
538