Effects of ceramic based pastes on electrochemical performance of solid oxide fuel cells

Basit Öğe Kaydı
dc.authorid0000-0001-6916-7720
dc.contributor.authorMat, Abdullah
dc.contributor.authorTimurkutluk, Bora
dc.contributor.authorTimurkutluk, Cigdem
dc.contributor.authorKaplan, Yuksel
dc.date.accessioned2019-08-01T13:38:39Z
dc.date.available2019-08-01T13:38:39Z
dc.date.issued2014
dc.departmentNiğde ÖHÜ
dc.description.abstractVarious commercially available anode and cathode materials are investigated as the anode and cathode contact paste, respectively, for solid oxide fuel cells. In order to obtain a printable paste, chosen materials are mixed with an organic vehicle and a thinner as well as a pore former. The effect of the contact materials on the cell performance is evaluated experimentally via cell performance measurements by installing a short stack. The pastes are brush painted on the corresponding interconnector and current collecting mesh. A short stack without any contact paste is also tested for comparison as a base case. The impedance and microstructural analyses are also performed through an impedance analyzer and a scanning electron microscope, respectively. The effects of solid loading for two anode and two cathode contact paste materials which provide the best two performances during the electrochemical performance tests are also studied. After optimizing the solid loading in the anode and cathode contact paste according to the performance results, the best contact materials for each side are decided. The final short stack is then installed by using the best combination of contact pastes and then tested. The final cell shows 0.39 W cm(-2) and 0.90 W cm(-2) peak power densities at 700 degrees C and 800 degrees C, respectively, whereas the base cell provides only 0.26 W cm(-2) peak power density at 800 degrees C. The improvement in the cell performance is considered to be due to the enhanced contact and better current collecting by employing contact pastes. (C) 2014 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
dc.identifier.doi10.1016/j.ceramint.2014.01.073
dc.identifier.endpage8583
dc.identifier.issn0272-8842
dc.identifier.issn1873-3956
dc.identifier.issue6
dc.identifier.scopus2-s2.0-84897427336
dc.identifier.scopusqualityQ1
dc.identifier.startpage8575
dc.identifier.urihttps://dx.doi.org/10.1016/j.ceramint.2014.01.073
dc.identifier.urihttps://hdl.handle.net/11480/4155
dc.identifier.volume40
dc.identifier.wosWOS:000335201800116
dc.identifier.wosqualityQ1
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.institutionauthor[0-Belirlenecek]
dc.language.isoen
dc.publisherELSEVIER SCI LTD
dc.relation.ispartofCERAMICS INTERNATIONAL
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.subjectSolid oxide fuel cells
dc.subjectCurrent collecting pastes
dc.subjectSolid loading
dc.subjectImpedance analysis
dc.subjectPerformance measurement
dc.titleEffects of ceramic based pastes on electrochemical performance of solid oxide fuel cells
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu