Simulations of interference and interfacial pressure for three disk shrink fit assembly

Basit Öğe Kaydı
dc.contributor.authorÖztürk F.
dc.contributor.authorWoo T.-C.
dc.date.accessioned2019-08-01T13:38:39Z
dc.date.available2019-08-01T13:38:39Z
dc.date.issued2010
dc.departmentNiğde ÖHÜ
dc.description.abstractIn this study, three disk shrink fit assembly (solid shaft-sleeve-holder) was modeled by finite element method to determine the effects of the interference or shrinkage allowance on interference or interfacial pressure. Stress distributions along the thickness were plotted. The highest stresses were observed at the inner surface of the holder. Solid shaft had a uniform stress distribution. Sleeve and holder had non uniform stress distributions, which were higher at the inner surface and lower at the outer surface. Higher stresses can be reduced by lowering the interference between the sleeve and the holder. Equal interfacial pressures between disks can be accomplished using different interferences. It was concluded that finite element simulation is the only solution for complex geometry and various loading conditions.
dc.identifier.endpage236
dc.identifier.issn1303-9709
dc.identifier.issue2
dc.identifier.scopus2-s2.0-77955522908
dc.identifier.scopusqualityQ3
dc.identifier.startpage233
dc.identifier.urihttps://hdl.handle.net/11480/1024
dc.identifier.volume23
dc.indekslendigikaynakScopus
dc.institutionauthor[0-Belirlenecek]
dc.language.isoen
dc.relation.ispartofGazi University Journal of Science
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.subjectInterference fit
dc.subjectShrink fit
dc.subjectShrink fit assembly
dc.subjectThree disk shrink fit
dc.titleSimulations of interference and interfacial pressure for three disk shrink fit assembly
dc.typeArticle

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu