Control of flow around a square prism by slot jet injection from the rear surface
Küçük Resim Yok
Tarih
2010
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
ELSEVIER SCIENCE INC
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
The flow around a square prism with slot jet injection from its base into the vortex formation region has been investigated experimentally for Reynolds number of 8000. For various injection rates, the mean and fluctuating pressure distributions on the square prism were measured and the velocity measurements were carried out by using a hot-wire anemometer. Flow visualization was performed by using the smoke-wire method. It was found that the slot jet injection has a substantial influence on the flow characteristics of the square prism. Increase of the injection ratio up to a certain value causes an important pressure recovery in the wake. For this lower range of blowing rates, blowing fluid tends to fill the wake region around the prism and extend it but the jet does not have enough momentum to penetrate the main vortices. By the further increasing of the blowing rate, the slot jet injection from the base side of the prism splits the near wake like a splitter plate. This causes a thinner wake width and weak vortices resulting in a higher vortex shedding frequency. (C) 2010 Elsevier Inc. All rights reserved.
Açıklama
Anahtar Kelimeler
Square prism, Blowing, Flow control, Slot jet injection, Vortex shedding, Pressure coefficient
Kaynak
EXPERIMENTAL THERMAL AND FLUID SCIENCE
WoS Q Değeri
Q1
Scopus Q Değeri
Q1
Cilt
34
Sayı
7
