Detailed Investigation of Forming Limit Determination Standards for Aluminum Alloys
Küçük Resim Yok
Tarih
2013
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
AMER SOC TESTING MATERIALS
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In this study, experimental studies were conducted to evaluate the differences between the ASTM E2218-02 and ISO 12004-2 standards that are used for construction of the forming limit curve (FLC) and that made various assumptions, which create dissimilar FLCs for the same material. The comparison was made for two materials which have moderate brittle and ductile characteristics, AA2024-T4 and AA5754-O alloys, respectively. The effects of a specimen's geometry, lubrication condition, and determination methods of limit strains on FLCs were considered and compared. Because the same strain evaluation method should be used for the standards, so as to be able to investigate the effect of only standards, a simple method in the computer grid analysis system was used. To test the validity and the reliability of the method, limit strains on the same specimens were also determined with using a real-time measurement method for the ISO experiments, and the results reveal that the method is reliable. Failure mechanisms were inspected for further investigation. The Nakajima specimens formed with the two standards showed different failure mechanisms. Finally, conducting the case studies, it was concluded that ISO 12004-2 yields more reliable and reproducible results than the ASTM standard.
Açıklama
Anahtar Kelimeler
ASTM E2218-02, ISO 12004-2, forming limit curve, failure
Kaynak
JOURNAL OF TESTING AND EVALUATION
WoS Q Değeri
Q4
Scopus Q Değeri
Q3
Cilt
41
Sayı
1
