The influence of aggregate type on the strength and abrasion resistance of high strength concrete

Basit Öğe Kaydı
dc.authorid0000-0003-3459-329X
dc.authorid0000-0001-7952-1025
dc.contributor.authorKilic, A.
dc.contributor.authorAtis, C. D.
dc.contributor.authorTeymen, A.
dc.contributor.authorKarahan, O.
dc.contributor.authorOzcan, F.
dc.contributor.authorBilim, C.
dc.contributor.authorOzdemir, M.
dc.date.accessioned2019-08-01T13:38:39Z
dc.date.available2019-08-01T13:38:39Z
dc.date.issued2008
dc.departmentNiğde ÖHÜ
dc.description.abstractThis paper examines the influence of aggregate type on the strength characteristics and abrasion resistance of high strength silica fume concrete. Five different aggregate types (gabbro, basalt, quartsite, limestone and sandstone) were used to produce high strength concrete containing silica fume. Silica fume replacement ratio with cement was 15% on a mass basis. Water-binder ratio was 0.35. The amount of hyperplasticizer was 4% of the binder content by mass. Gabbro concrete showed the highest compressive and flexural tensile strength and abrasion resistance, while sandstone showed the lowest compressive and flexural tensile strength and abrasion resistance. High abrasion resistant aggregate produced a concrete with high abrasion resistance. Three-month compressive strengths of concretes made with basalt, limestone and sandstone were found to be equivalent to the uniaxial compressive strengths of their aggregate rocks. However, the concretes made with quartsite and gabbro aggregate showed lower compressive strength than the uniaxial compressive strength of their aggregate rocks. (c) 2007 Elsevier Ltd. All rights reserved.
dc.identifier.doi10.1016/j.cemconcomp.2007.05.011
dc.identifier.endpage296
dc.identifier.issn0958-9465
dc.identifier.issn1873-393X
dc.identifier.issue4
dc.identifier.scopus2-s2.0-39449120510
dc.identifier.scopusqualityQ1
dc.identifier.startpage290
dc.identifier.urihttps://dx.doi.org/10.1016/j.cemconcomp.2007.05.011
dc.identifier.urihttps://hdl.handle.net/11480/5257
dc.identifier.volume30
dc.identifier.wosWOS:000255086900005
dc.identifier.wosqualityQ1
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.institutionauthor[0-Belirlenecek]
dc.language.isoen
dc.publisherELSEVIER SCI LTD
dc.relation.ispartofCEMENT & CONCRETE COMPOSITES
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.subjectaggregate types
dc.subjectconcrete
dc.subjectstrength
dc.subjectabrasion
dc.titleThe influence of aggregate type on the strength and abrasion resistance of high strength concrete
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu