Simulations of Interference and Interfacial Pressure for Three Disk Shrink Fit Assembly

Basit Öğe Kaydı
dc.authoridOzturk, Fahrettin/0000-0001-9517-7957
dc.contributor.authorOzturk, Fahrettin
dc.contributor.authorWoo, Tse-Chien
dc.date.accessioned2024-11-07T13:32:14Z
dc.date.available2024-11-07T13:32:14Z
dc.date.issued2010
dc.departmentNiğde Ömer Halisdemir Üniversitesi
dc.description.abstractIn this study, three disk shrink fit assembly (solid shaft-sleeve-holder) was modeled by finite element method to determine the effects of the interference or shrinkage allowance on interference or interfacial pressure. Stress distributions along the thickness were plotted. The highest stresses were observed at the inner surface of the holder. Solid shaft had a uniform stress distribution. Sleeve and holder had non uniform stress distributions, which were higher at the inner surface and lower at the outer surface. Higher stresses can be reduced by lowering the interference between the sleeve and the holder. Equal interfacial pressures between disks can be accomplished using different interferences. It was concluded that finite element simulation is the only solution for complex geometry and various loading conditions.
dc.identifier.endpage236
dc.identifier.issn2147-1762
dc.identifier.issue2
dc.identifier.startpage233
dc.identifier.urihttps://hdl.handle.net/11480/15308
dc.identifier.volume23
dc.identifier.wosWOS:000421106800014
dc.identifier.wosqualityN/A
dc.indekslendigikaynakWeb of Science
dc.language.isoen
dc.publisherGazi Univ
dc.relation.ispartofGazi University Journal of Science
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.snmzKA_20241106
dc.subjectShrink fit
dc.subjectShrink fit assembly
dc.subjectInterference fit
dc.subjectThree disk shrink fit
dc.titleSimulations of Interference and Interfacial Pressure for Three Disk Shrink Fit Assembly
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu