Experimental Research and Mathematical Modeling of Parameters Effecting on Cutting Force and SurfaceRoughness in CNC Turning Process
Küçük Resim Yok
Tarih
2018
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Institute of Physics Publishing
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
In this paper, the effects of cutting parameters on cutting forces and surface roughness based on Taguchi experimental design method are determined. Taguchi L9 orthogonal array is used to investigate the effects of machining parameters. Optimal cutting conditions are determined using the signal/noise (S/N) ratio which is calculated by average surface roughness and cutting force. Using results of analysis, effects of parameters on both average surface roughness and cutting forces are calculated on Minitab 17 using ANOVA method. The material that was investigated is Inconel 625 steel for two cases with heat treatment and without heat treatment. The predicted and calculated values with measurement are very close to each other. Confirmation test of results showed that the Taguchi method was very successful in the optimization of machining parameters for maximum surface roughness and cutting forces in the CNC turning process. © Published under licence by IOP Publishing Ltd.
Açıklama
Petroyag Lubricants;UCTEA Chamber of Mechanical Engineers
9th International Conference on Tribology, Balkantrib 2017 -- 13 September 2017 through 15 September 2017 -- -- 135934
9th International Conference on Tribology, Balkantrib 2017 -- 13 September 2017 through 15 September 2017 -- -- 135934
Anahtar Kelimeler
Cutting force, Inconel 625, Surface roughness, Taguchi design of experiments, vibrations and temperature
Kaynak
IOP Conference Series: Materials Science and Engineering
WoS Q Değeri
N/A
Scopus Q Değeri
N/A
Cilt
295
Sayı
1
