Experimental Research and Mathematical Modeling of Parameters Effecting on Cutting Force and SurfaceRoughness in CNC Turning Process

Basit Öğe Kaydı
dc.contributor.authorZeqiri F.
dc.contributor.authorAlkan M.
dc.contributor.authorKaya B.
dc.contributor.authorToros S.
dc.date.accessioned2019-08-01T13:38:39Z
dc.date.available2019-08-01T13:38:39Z
dc.date.issued2018
dc.departmentNiğde ÖHÜ
dc.descriptionPetroyag Lubricants;UCTEA Chamber of Mechanical Engineers
dc.description9th International Conference on Tribology, Balkantrib 2017 -- 13 September 2017 through 15 September 2017 -- -- 135934
dc.description.abstractIn this paper, the effects of cutting parameters on cutting forces and surface roughness based on Taguchi experimental design method are determined. Taguchi L9 orthogonal array is used to investigate the effects of machining parameters. Optimal cutting conditions are determined using the signal/noise (S/N) ratio which is calculated by average surface roughness and cutting force. Using results of analysis, effects of parameters on both average surface roughness and cutting forces are calculated on Minitab 17 using ANOVA method. The material that was investigated is Inconel 625 steel for two cases with heat treatment and without heat treatment. The predicted and calculated values with measurement are very close to each other. Confirmation test of results showed that the Taguchi method was very successful in the optimization of machining parameters for maximum surface roughness and cutting forces in the CNC turning process. © Published under licence by IOP Publishing Ltd.
dc.identifier.doi10.1088/1757-899X/295/1/012011
dc.identifier.issn1757-8981
dc.identifier.issue1
dc.identifier.scopus2-s2.0-85046296507
dc.identifier.scopusqualityN/A
dc.identifier.urihttps://dx.doi.org/10.1088/1757-899X/295/1/012011
dc.identifier.urihttps://hdl.handle.net/11480/1689
dc.identifier.volume295
dc.identifier.wosWOS:000448617300011
dc.identifier.wosqualityN/A
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.institutionauthor[0-Belirlenecek]
dc.language.isoen
dc.publisherInstitute of Physics Publishing
dc.relation.ispartofIOP Conference Series: Materials Science and Engineering
dc.relation.publicationcategoryKonferans Öğesi - Uluslararası - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/openAccess
dc.subjectCutting force
dc.subjectInconel 625
dc.subjectSurface roughness
dc.subjectTaguchi design of experiments
dc.subjectvibrations and temperature
dc.titleExperimental Research and Mathematical Modeling of Parameters Effecting on Cutting Force and SurfaceRoughness in CNC Turning Process
dc.typeConference Object

Dosyalar

Koleksiyon

Scopus İndeksli Yayınlar Koleksiyonu
WoS İndeksli Yayınlar Koleksiyonu