Effect of Heat Treatment on the Microstructures and Mechanical Properties of Al-4Cu-1.5Mg Alloy
Küçük Resim Yok
Tarih
2022
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Springer Int Publ Ag
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In this work, the influence of different heat treatments (HT) processes on the microstructure and mechanical properties of cast Al-4Mg-1.5 Mg alloy was investigated. To investigate the effect of HT, firstly Al-4Cu-1.5Mg samples were homogenized (solution treatment) at 500 degrees C/2h, water quenched at room temperature (RT) and then immediately exposed to an artificial aging process at 200 degrees C for various aging times of 1, 4, 8, 12, 16, 20 and 24 hours. Quantitative examinations after HT processes (solution treatment and aging) have shown that intermetallic phases (Al2Cu and Al2CuMg) were dissolved in the alpha-Al matrix phase and distributed along the grain boundary. Some mechanical properties (HV sigma, sigma(TYS), sigma(UTS), sigma(CYS), E and delta) of a sufficient number of alloy samples exposed to different heat treatments were examined in detail. The data obtained show that the conditions of solution treatment and aging in some conditions show superior mechanical properties than the sample in the form as-cast. The highest microhardness value (126 HV) was obtained for the alpha-Al matrix phase, which was subjected to solution treatment (only homogenization). After aging for 1h at 200 degrees C, the peak value of microhardness was achieved as 289.5 HV for intermetallic phases. The highest tensile strength (sigma(UTS)) was obtained as 328 MPa for the sample which aged for 8h at 200 degrees C after solution treatment for 2h at 500 degrees C.
Açıklama
Anahtar Kelimeler
2xxx alloy, solution treatment, artificial aging, microhardness, tensile strength, yield strength
Kaynak
International Journal of Metalcasting
WoS Q Değeri
Q2
Scopus Q Değeri
Q2
Cilt
16
Sayı
2
